There's a general consensus that we won't be able to consistently perform sophisticated quantum calculations without the development of error-corrected quantum computing, which is unlikely to arrive until the end of the decade. It's still an open question, however, whether we could perform limited but useful calculations at an earlier point. IBM is one of the companies that's betting the answer is yes, and on Wednesday, it announced a series of developments aimed at making that possible.

On their own, none of the changes being announced are revolutionary. But collectively, changes across the hardware and software stacks have produced much more efficient and less error-prone operations. The net result is a system that supports the most complicated calculations yet on IBM's hardware, leaving the company optimistic that its users will find some calculations where quantum hardware provides an advantage.

Better hardware and software

IBM's early efforts in the quantum computing space saw it ramp up the qubit count rapidly, being one of the first companies to reach the 1,000 qubit count. However, each of those qubits had an error rate that ensured that any algorithms that tried to use all of these qubits in a single calculation would inevitably trigger one. Since then, the company's focus has been on improving the performance of smaller processors. Wednesday's announcement was based on the introduction of the second version of its Heron processor, which has 156 qubits (up from an earlier 133 in Revision 1). That's still beyond the capability of simulations on classical computers, should it be able to operate with sufficiently low errors.

Read full article

Comments

As we described earlier this year, operating a quantum computer will require a significant investment in classical computing resources, given the amount of measurements and control operations that need to be executed and interpreted. That means that operating a quantum computer will also require a software stack to control and interpret the flow of information from the quantum side.

But software also gets involved well before anything gets executed. While it's possible to execute algorithms on quantum hardware by defining the full set of commands sent to the hardware, most users are going to want to focus on algorithm development, rather than the details of controlling any single piece of quantum hardware. "If everyone's got to get down and know what the noise is, [use] performance management tools, they've got to know how to compile a quantum circuit through hardware, you've got to become an expert in too much to be able to do the algorithm discovery," said IBM's Jay Gambetta. So, part of the software stack that companies are developing to control their quantum hardware includes software that converts abstract representations of quantum algorithms into the series of commands needed to execute them.

IBM's version of this software is called Qiskit (although it was made open source and has since been adopted by other companies). Recently, IBM made a couple of announcements regarding Qiskit, both benchmarking it in comparison to other software stacks and opening it up to third-party modules. We'll take a look at what software stacks do before getting into the details of what's new.

Read full article

Comments